Skylight Installation and Replacement

Our local roofer installs, replaces and repairs skylights on North Branch homes. A new skylight goes in an opening cut and framed in the roof, then is flashed and shingled around. A leaking skylight with sound glass can usually be repaired.

Request a Roof Inspection

Fill in the form below or call us now on (651) 427-2051

Best way to reach you

Thanks, we've passed your request to our local roofer and they'll be in touch shortly.

Repair or Replace a Leaking Skylight?

Repair a leaking skylight when the glass and frame are sound and the water gets in at the flashing or seal; replace it when the glazing is cracked or fogged between the panes, the frame is rotted or corroded, or the unit is old enough that new flashing would outlast it.

A skylight repair runs about $300 to $500, against $800 to $2,200 to replace the unit. Both are national figures and not a quote. If the leak is at the flashing, see roof flashing repair.

Repair the skylight

  • Water stains around the opening, glass intact
  • Cracked sealant or lifted flashing outside
  • Frame solid and dry when pressed
  • The roof around it still has years left

Replace the skylight

  • Cracked glass or fog between the panes
  • Rotted, corroded or cracked frame
  • Leaks that came back after resealing
  • A new roof going on, so the opening is exposed anyway

What Skylight Installation Costs

Skylight installation costs about $1,014 to $2,828 for a typical job, with an average of $1,920. That is a national range and not a quote.

The unit itself is only part of it. Professional installation adds $300 to $2,500, more where new framing or an electrician for a powered vent is needed.

Skylights by type, national ranges

Unit cost
TubularSmall dome, flexible tube
$200–$500
FixedDoes not open
$200–$900
VentilatingOpens by crank or motor
$400–$2,000

Want a real price for a skylight?

Our local roofer will look at your roof and give you a written estimate. Send a few details or call (651) 427-2051.

Get Estimate →

How a Skylight Is Installed in a Roof

A skylight is installed in a roof by marking the opening between rafters, cutting the deck, framing the hole with headers, setting the skylight on a curb or its own frame, and sealing it with underlayment, flashing and shingles before the inside is finished.

  1. 1

    Frame the opening

    Minnesota code requires roof openings to be framed with header and trimmer joists. Trusses cannot be cut without a registered design professional's approval.

  2. 2

    Set the curb

    A 2x8 raised curb is the suggested minimum to get flashing clearance.

  3. 3

    Turn up the underlayment

    Waterproofing underlayment is lapped up the sides of the curb before any metal goes on.

  4. 4

    Flash it

    Backer flashing runs under the shingles at least three courses above, with step and counterflashing up the sides.

  5. 5

    Finish inside

    The light shaft is framed, insulated and drywalled down to the ceiling.

Three large dark-framed roof windows set into a steep black tile roof below a metal gutter, seen from the outside

Minnesota Code Rules for Skylights

Minnesota's code requires a skylight on a roof flatter than 3:12 to sit on a curb at least 4 inches high, requires safety glazing such as tempered or laminated glass, and requires every unit skylight to carry a label showing it was tested to the AAMA/WDMA/CSA 101 standard.

4 inMinimum curb height on roofs flatter than 3:12, unless the manufacturer says otherwise
Safety glassLaminated, fully tempered, heat-strengthened or wired glass, or approved rigid plastic
LabeledTested by an independent lab to AAMA/WDMA/CSA 101/I.S.2/A440

Want our local roofer to take a look?

Send a few details or call (651) 427-2051, and our local roofer will come and look.

Get Estimate →

Do Skylights Cause Ice Dams?

Skylights can add to ice dams. They are among the features that increase the risk of ice dam formation, alongside recessed lights, complex roof shapes and heating ducts in the attic.

A skylight shaft carries room heat up through the attic insulation to the roof deck around it.

Sealing and insulating the shaft walls as well as the attic floor reduces that; see attic insulation and air sealing. A skylight on the lower roof also needs the ice barrier Minnesota requires at the eaves.

Skylights and ice dams

Higher ice dam risk

Skylights are among the features that raise it.

Who Can Install a Skylight in Minnesota?

A skylight can be installed by a contractor with a Minnesota residential building contractor or remodeler license. The job is both carpentry and roofing, and a roofer-only license covers just the roofing. Our local roofer installs and replaces skylights, so ask for their license number when you book.

Minnesota law lists skylights under carpentry, with doors and windows. Roofing covers the roof covering, sheathing, weatherproofing and repairs to the roof support. Work that crosses both needs the building contractor or remodeler license.

You can check any license on the DLI lookup. Our page on checking a roofer's license shows how.

Before you book

Ask for the license number

A roofer-only license does not cover skylight installation.

Skylight FAQs

How much does it cost to put in a skylight?

About $1,014 to $2,828 for a typical job, averaging $1,920. That is a national range, not a quote.

How much does it cost to replace a skylight?

About $800 to $2,200 to replace the unit, plus $50 to $200 to remove the old one. A repair is usually $300 to $500. These are national figures, not quotes.

Should I replace my skylight when I replace the roof?

Often, yes, if the skylight is old. The flashing around it comes off during the tear-off anyway, and a new unit flashed with the new roof avoids opening the roof again later. See roof replacement.

Is there a tax credit for a new skylight?

Not for one installed in 2026. The energy efficient home improvement credit, which included skylights, is not allowed for any property placed in service after December 31, 2025.

What is a tubular skylight?

A small dome on the roof with a reflective tube down to a ceiling diffuser. It needs no new framing, and the unit costs about $200 to $500, a national range.

Get a skylight estimate

Tell us whether it is a new skylight or a replacement, whether the old one leaks, and roughly how steep the roof is. We pass it to our local roofer, who will tell you how they handle skylight work and price it.

Call now (651) 427-2051 Roofing in North Branch and the towns around it

Request a Roof Inspection

Fill in the form below or call us now on (651) 427-2051

Best way to reach you *

Thanks, we've passed your request to our local roofer and they'll be in touch shortly.