Flat Roof Repair
Our local roofer repairs flat roofs over garages, porches, additions and houses around North Branch. They fix the seam, flashing, blister or puncture letting water in. Most leaks can be repaired if they are caught before the insulation and deck get soaked.
Signs Your Flat Roof Needs Repair
Your flat roof needs repair when you see a ceiling stain or drip below it, water that stays on the roof for days, seams or flashing lifting at the edges, blisters or cracks in the surface, or a soft spot underfoot.
Flat roofs fail at their details first. The field of the roof is usually fine long after the seams, the wall flashing and the seal around pipes and vents have started to let go.
- Ceiling stains or drips under the flat roof
- Water pooling for days after rain
- Lifted seams or loose edge metal
- Blisters, bubbles or cracked surfacing
- Gaps where the roof meets a wall
- Soft or spongy areas when walked on
Don't wait
Wet insulation spreads
Water under a flat roof spreads sideways, so a small leak left alone can turn a repair into a replacement.
What Flat Roof Repair Costs
Flat roof repair costs about $400 on average for a flat or single-ply roof, and general leak repairs run $350 to $1,500. These are national figures, not a quote.
Small seam and flashing repairs sit at the low end. The price climbs when the roofer has to cut out wet insulation, replace soft deck or rebuild flashing along a whole wall. Larger areas can run $3.50 to $11 per square foot.
Roof repair, national ranges
Per repair jobWant a real price for flat roof repair?
Our local roofer will look at your roof and give you a written estimate. Send a few details or call (651) 427-2051.
Common Flat Roof Repairs
The most common flat roof repairs are re-sealing open seams, patching punctures and blisters, rebuilding flashing at walls and pipes, and clearing or fixing drains and scuppers so water can leave the roof.
How each repair is made depends on the roof. EPDM rubber is patched with tape, TPO and PVC are heat-welded, and asphalt roofs get new plies and mastic.
Open seams
Seams that have lifted are cleaned and re-taped, re-glued or re-welded to match the membrane.
Punctures
Holes from branches, tools or hail get a patch of the same material, sealed well past the damage.
Blisters
On a modified bitumen or built-up roof, blisters are cut open, dried and covered.
Wall flashing
Where a flat roof meets a house wall, the membrane is turned up and sealed; see roof flashing repair.
Pipes and vents
Boots and pitch pans around pipes and vents are resealed or replaced.
Drains and scuppers
Clogged or sunken drains are cleared and reset so water runs off instead of pooling.
How a Flat Roof Leak Is Found and Fixed
A flat roof leak is found by tracing water from the inside stain back to a failed seam, flashing or penetration on the roof, and it is fixed by repairing that spot with matching material and replacing anything that got wet.
- 1
Look inside
The roofer notes where water shows and what sits on the roof above it.
- 2
Inspect the roof
Seams, flashing, edges, drains and penetrations near the stain are checked.
- 3
Check for wet layers
Soft spots tell the roofer how far water has spread under the surface.
- 4
Repair
The failed spot is fixed, and any soaked insulation or rotted deck is replaced.
Want our local roofer to take a look?
Send a few details or call (651) 427-2051, and our local roofer will come and look.
Flat Roofs and Minnesota Winters
Flat roofs take a hard beating in Minnesota winters because they hold snow instead of shedding it, ice can block drains and edges, and meltwater that refreezes works into any open seam.
The state sets a 50 psf ground snow load for Chisago County. On a flat section that adjoins a heated house, ice dams can form too. They need snow on the roof while higher parts of the roof are above 32 degrees F and lower parts are below it. See ice dam prevention for the long-term fix.
Chisago County
50 psf
Ground snow load the state sets for Chisago, Isanti, Anoka and Washington counties.
Repair or Replace a Flat Roof?
Repair a flat roof when the problem is one or two spots and the layers underneath are dry; replace it when it leaks in many places, the deck is soft, or the surface is worn out across the roof.
If replacement makes more sense, our page on flat roof replacement covers cost and permits in North Branch.
Repair
- One or two leaks you can point to
- Damage at a seam, pipe or wall
- Dry insulation and firm deck
- Roof still flexible elsewhere
Replace
- Leaks in several places
- Soft deck or wet insulation over a wide area
- Cracked, blistered or shrunken surface
- Patches that keep failing
Flat Roof Repair FAQs
How much does flat roof repair cost?
About $400 on average for a flat or single-ply roof, with leak repairs generally $350 to $1,500. Those are national figures, not a quote.
Can a flat roof be patched in winter?
Often, temporarily. Many adhesives, sealants and welds have manufacturer temperature limits, so the roofer may make a temporary repair in the cold and finish it properly when the weather allows.
Why does water sit on my flat roof?
Usually because a drain or scupper is blocked, the deck has sagged, or the roof was built without enough slope. Water that sits for days wears the surface and finds every weak seam.
Can I coat my flat roof instead of repairing it?
Only if the roof is dry and sound. A roof coating can extend the life of a good roof, but it does not fix wet insulation or a soft deck underneath.
Is it a commercial job if the flat roof is on my business?
Yes. For shops, offices and other business buildings, see commercial roof repair.
Get a flat roof repair estimate
Tell us where the leak shows, what the roof covers and what it is made of if you know. Our local roofer will find the cause and price the repair.
Call now (651) 427-2051 Roofing in North Branch and the towns around it